This is a special limited edition release! Only 20 of each style.

Fits either the Leatherman ARC or Leatherman Wave Alpha
Custom milled by a community member in the USA
Made from an ultra high quality copper alloy
Your choice of aggressive or more subtle knurling
Specially made in a Fallout game series theme. (Bottle cap or Vault Door style)
Polished finish
Threads are DLC coated to prevent galvanic metal interaction
Grey plastic tool included to aid in re-polishing the top surface
Knurled installation tool included
Thread locker included (US only)
Alcohol cleanup pad included

Installation:

For safety ensure the blade is in the closed position.
A T6 Torx bit is required to remove your factory stud (Sold separately)
Remove the factory thumb stud from your blade.
Carefully unthread the thumb-stud from the yellow carrier.
Place the stud into the installation tool (There is a coarse and fine side).
Apply a small amount of blue thread locker to the threads only
Tighten the thumb stud against the blade.
Clean off any thread locker that may have spilled out.
Clean the surface of the thumb-stud using the a cotton cloth.

Removal:

The thread size on the studs is very small, and you could break the threads off if you attempt to untwist the stud using brut force.

If you used thread locker on the stud, then you must break the thread locker bond using heat. This can be done by use of a soldering iron, heat gun or torch. Reaching a temperature of 250c. Take care not to overheat the area, which can cause distortion of the blade. Apply a bit of heat, and try gently twisting the stud using needle nose pliers. If it doesn't loosen, try a bit more heat.

For more tips see here: How to remove thread locker

Polishing:

Remove the thumb-stud and thread it onto the included grey polishing jig.
Place the jig into a drill chuck.
While spinning the jig and stud, lightly press it against a cotton cloth.
You may apply some polishing compound a cotton cloth to aid in polishing.
1200 grit sandpaper may be used to remove deep scratches
Finish with 5000-7000 grit sand paper

FAQ:

Q: What is the foam pad that in inside the package?
- A: That is a VCI corrosion inhibitor foam, to keep the copper glossy during storage.

Spring Break